View Profile: giogi - Copytechnet.com

28 Minutes Ago

skynet replied to a thread search / advanced search in Site Feedback & Questions

My app mentioned earlier was nothing more than a pipe dream, the fact that I know nothing about coding didn't help. It ran on Linux but to get it...

12 replies | 1430 view(s)

2 Hours Ago

copier tech replied to a thread MPC 406 No air print in Ricoh, Savin, Gestetner, Lanier

The MP C306 / C406 don't support AirPrint. About AirPrint – Apple Support (UK)

3 replies | 122 view(s)

7 Hours Ago

bobburnsreb replied to a thread Canon DR-G2110 weird striped scanned images in Canon

send me your email address maybe I can help

3 replies | 281 view(s)

12 Hours Ago

copier tech started a thread [Misc] XC9335 disable drum life / end warning in Lexmark

Hi all, Is it possible to stop this device from calling for a drum when it has expired ? becuase If they client doesn't notice the initial drum...

0 replies | 110 view(s)

12 Hours Ago

copier tech replied to a thread [Jamming] Bizhub C250i FS-539SD jamming code J7225 in Konica Minolta

Yes, it was the front blade mount was cracked at one end so the blade / knife wasn't returning home level preventing the paper from passing.

6 replies | 754 view(s)

12 Hours Ago

copier tech replied to a thread I'm having difficulty finding a parts manual for a ricoh pb 3220 in Ricoh, Savin, Gestetner, Lanier

Here's the parts manual.

1 replies | 161 view(s)

1 Day Ago

copier tech replied to a thread IMC3000/3500 Shortcut Scan To folder in Ricoh, Savin, Gestetner, Lanier

Same, we set all our new devices with the classics legacy apps only & delete the 'new' apps off the home screen. Lucky the new C3010 series still...

8 replies | 671 view(s)

1 Day Ago

copier tech replied to a thread [Misc] Canon IR Advance 6055 - The Photocopy Result is faded at the bottom of the paper in Canon

Does the technician or yourself have the service manual ? if so there is a troubleshooting section covered in there.

4 replies | 289 view(s)

1 Day Ago

copier tech replied to a thread Scan to Email using office365 in Ricoh, Savin, Gestetner, Lanier

Turn on DHCP, check your gateway is correct then try a connection test on smtp.gmail.com (your DNS will need to be correct too.) then try...

6 replies | 337 view(s)

1 Day Ago

Brian8506 replied to a thread [Misc] Canon IR Advance 6055 - The Photocopy Result is faded at the bottom of the paper in Canon

I just had a similar problem. There may be a broken gear on the back of the developing unit or the stirring rod inside of developing unit might be...

4 replies | 289 view(s)

1 Day Ago

Brian8506 replied to a thread [Misc] Canon IR Advance 6055 - The Photocopy Result is faded at the bottom of the paper in Canon

We need to know what he's done so far. There's wires, the developer cylinder, possible bad toner, clean out dv unit and start fresh, transfer belt,...

4 replies | 289 view(s)

1 Week Ago

copier tech replied to a thread Kyocera Ecosys P5021cdw Firmware in Kyocera, UTAX, Copystar

We can supply the latest firmware for this device. Feel free to contact us via either website below should you still require it.

4 replies | 281 view(s)

1 Week Ago

copier tech replied to a thread iRADV8595 firmware can't update in Canon

Are you using the correct system software, is your device the 3rd generation or the previous version ?

6 replies | 398 view(s)

1 Week Ago

copier tech replied to a thread Ricoh c6503 error sc672-00 & manual in Ricoh, Savin, Gestetner, Lanier

Try updating the firmware (via SD card) if this works then most likely the controller board is OK. It the device throws the SC672 then you'll need to...

13 replies | 1140 view(s)

1 Week Ago

zoraldinho replied to a thread Cyan toner leak in Canon V 1000. in Canon

If there is toner, then the gasket on the hopper is not in position. If it throws you developer (starter)=Dcontroler

2 replies | 431 view(s)

1 Week Ago

zoraldinho replied to a thread ADV 527i faded copies in Canon

From the summer of 2022, there are no more of these problems.

3 replies | 208 view(s)

1 Week Ago

zoraldinho replied to a thread [Misc] Scanned documents skewed when scanning double sided documents on canon ir adv dx 5740 in Canon

The manufacturer has Measure against skew when the document is fed from DADF-C. A long procedure for height adjustments and in service mode...

1 replies | 236 view(s)

1 Week Ago

Brian8506 replied to a thread ADV 527i faded copies in Canon

I’ve had a few go light early. Sent from my iPhone using Tapatalk

3 replies | 208 view(s)

1 Week Ago

zoraldinho replied to a thread [CQ] Canon imageRUNNER C3826i pinting issue in Canon

Use the laser cleaning stick from the inside of the toner door and clean laser scanner. After that make a full gradation.

1 replies | 260 view(s)

1 Week Ago

zoraldinho replied to a thread iRADV8595 firmware can't update in Canon

Something did not load correctly with sst. Can you use cds upgrade? (via network)

6 replies | 398 view(s)

1 Week Ago

Brian8506 replied to a thread Canon IR ADV C5255 error code E355-004 in Canon

I missed the different model part. Even if you have the same model machine the small boards need to stay with the original machine

5 replies | 289 view(s)

1 Week Ago

Brian8506 replied to a thread Canon IR ADV C5255 error code E355-004 in Canon

The 2 little boards on the main controller need to stay with the machine. Put the original counter and serial number pcb back with the original...

5 replies | 289 view(s)

1 Week Ago

copier tech replied to a thread mpc305,mpc307,mpc407 toners,drum and other parts info needed in Ricoh, Savin, Gestetner, Lanier

No, most parts are not interchangeable with the C305.

5 replies | 278 view(s)

1 Week Ago

copier tech replied to a thread mpc305,mpc307,mpc407 toners,drum and other parts info needed in Ricoh, Savin, Gestetner, Lanier

The MP C307 & 407 are basically the same machine, only difference is the speed. Not a bad model. PCDU don't always reach life & had a few with the...

5 replies | 278 view(s)

1 Week Ago

copier tech replied to a thread Trying to upgrade from Q8 to GC2-Q9 locks the display and doesn't work. in Konica Minolta

We run into this issue from time to time. A few weeks ago at a large college I was running round updating a load of iseries & the odd one or two...

5 replies | 452 view(s)

1 Week Ago

mramlawi replied to a thread IR Advance 4525i fixing film in Canon

Hello , yes this model the weak point on it the fuser film life is not high, you can use the for use quality but it will make around 30k max , same...

5 replies | 349 view(s)

1 Week Ago

Brian8506 replied to a thread IR Advance 4525i fixing film in Canon

I have found they don’t work well. Nationwide in Kansas sells the film assembly or the whole assembly. Reasonable price Sent from my iPhone...

5 replies | 349 view(s)

1 Week Ago

copier tech replied to a thread [Jamming] Paper misfeed even though tray is empty in Ricoh, Savin, Gestetner, Lanier

Take the paper out of the LCT, go to the copy screen, does the LCT still show it has paper loaded ?

7 replies | 431 view(s)