muratec mfx-2700

[mazen]

hi....for all
i need help for any one have error code for muratec mfx-2700
my problem is call service memory 18
how i can solve this problem ?
thanks for all with my best..............

[BoBa]

18: Fuser error
Causes:
When the fuser miss to fill out the following conditions:
(The number indicates the detailed error code on the LCD)
4 The fuser does not become to temperature (Temp 2 :150 °C) within 60 seconds.
5 The fuser detected a temperature higher than 250 °C.
6 The fuser does not become warmer more than 8 seconds during printing.
7 The fuser detected a lower temperature than 35 °C after the heater is set to ON for four seconds.
8 The fuser detected a higher temperature than 190 °C for 50 ms when sleep mode temperature
(35 °C ) and standby mode temperature (145 °C ) is set up.
Suggested corrective action:
1. Turn on the power again, and verify the fuser warms up.
2. Check the connection between Fusing thermistor and PCB Main.
3. Check the connection between PCB Main and LVPS.
4. Check the connection between Fuser and LVPS.
5. Replace the Fuser.
6. After Replace the fuser, verify the fuser warms up when the power is ON.
7. Replace the PCB Main.
8. After Replace the PCB Main, verify the fuser warms up when the power is ON.
9. Replace the LVPS.

[mazen]

thank you my friend BoBa to reply........
can i get the program for the service mode or how i can enter to service mode for this machine
thanks with my best

[JustManuals]

This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals | The Internet's largest selection of manuals | Instant Downloads


Paul@justmanuals.com

[mazen]

i need help only...........
i will thanks any person help me.............

[mazen]

i need service manual for muratec mfx-c2700 can any one help me????????
thanks

[JustManuals]

See above.

[saripuli]

Hi,

I also need Muratec MFX-2700 Service manual, please send me if any one has one.
mail saripuli@gmail.com