Having issues scanning off the glass and doc feeder, the image is about 1/8 in off the top of the page. Printing is actually fine. Is there an adjustment in service mode that will center the image or change the horizontal scan position? Found some adjustment codes but not sure which one is the right code.
Thanks for any replies.
Kyocera Optical Adjustments.jpg
This is the order of adjustments of the Alphard 1 & 2.
I know you're probably not going to take my advice, but I always do the full procedure beginning to end. You will find that if you start in the middle, you will find yourself circling around again and again, repeating the same adjustments again & again because the adjustment you just did changed something else.
See attached:
=^..^=
Last edited by blackcat4866; 06-16-2022 at 02:32 AM.
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Thanks Again Blackcat.
Posting Permissions
Thanks: 
Likes: 
Dislikes: 
Reply With Quote
Bookmarks