Dell 5130 (Xerox Phaser 6700), Lost NVM Values? Error 006-370 with IOT: 00000003h

[k3wf3w]

Have you done that procedure to load from ESS? If not, give it a shot.

Yes I did. Still same error during boot. I am sure the laser is fine though. Any more idea's? I noticed an option to Init NVM, in CE mode. I have also been able to get into Firmware Load mode, where it has options to load firmware from USB, Serial, etc. Sorry about the questions and ramblings, just trying to bounce some ideas off you.
Thanks!

[Lance15]

Hmmm. I'm out of ideas other than the FIP troubleshooting for that error.

[tcook]

I know this is an old thread, but I came across it in my search for this error. There is a microswitch activated by the back cover. If you try to run the machine with the cover off, it throws this same error - 006-370, IOT 00000003h. Cheat the switch or put the cover on and it's fine.