Hallo,
does anybody know how to fix error 100016 on WF-C5790?
At start the machine is locked and the scanner and copy does not work, but printer is ok.
Any idea?
Thank you very much
Hallo,
does anybody know how to fix error 100016 on WF-C5790?
At start the machine is locked and the scanner and copy does not work, but printer is ok.
Any idea?
Thank you very much
Check the connection state of the ADF/SCN
cables
Connect the two ADF/SCN cables to the Main
Board Assy again.
Did the error occur after connecting the cables
again?
Go to step 2 End
2 Check the connection state of the CIS module
FFC
Is the CIS module correctly connected to the ADF/
SCN main board?
Replace the
ADF/SCN
Unit.
Reconnect
the SCN
CIS module
hi i have the same problem in a 5710
I have already reviewed those components, the machine sometimes starts without problems but after a while the error returns, the manufacturer recommends a firmware update, I already put the Japanese version and I did not succeed.
apparently it is a fatal error of certain models with a certain serial number, is there any way to leave the machine as a printer only, even if the scanner does not work???
[QUOTE=cdvidaceiba;2109858] merhaba 5710'da da aynı sorun
var Bu bileşenleri zaten inceledim, makine bazen sorunsuz başlıyor ancak bir süre sonra hata geri dönüyor, üretici bir bellenim güncellemesi öneriyor, zaten Japonca sürümünü koydum ve başaramadım.
görünüşe göre bu, belirli bir seri numarasına sahip belirli modellerin ölümcül bir hatasıdır, tarayıcı çalışmasa bile makineyi yalnızca yazıcı olarak bırakmanın herhangi bir yolu var mı??? [/ALINTI YAPMAK]
You can run the machine in technical mode and put it in print mode. It can stay in print mode unless you turn it off with the on/off button.
In the aforementioned fault code, adf unit and main board replacement is required.
how i do that ....i know how to enter to tecnical mode but do not know how to activate that mode . can you teach me how
thanks in advance
I finally know how to fix error 100016 with error m5799 and c5790. This is a problem with the board and the chip on the board. 20 boards have already been repaired.
I have a bunch and have swapped adf's and error comes back. Replaced main board and error never came back.
if you didn't throw the boards in the trash, I can fix theml
Bookmarks