Pro C 5100 issues

[barber782]

Hi everyone,

Iv got problems with a pro c5100 machine. I have recently replaced the transfer belt and sensor assembly. After replacement i have done the procedures shown in service manual, but have had no success. The colour registration is all off, and even doing auto colour reg calibration fails, and all other calibration setgings fail within service mode. Also every now and then I get a sc285-00 code.

Any support would be great.

Thanks

[mita]

I had a similar issue on a Proc5110 found that when I cut the tie band on a two wire jumper between the pcb's in the transfer belt assy the issue went away.

[barber782]

Hi. Tried cutting the tie for that wire but still no luck. Im getting really bad colour reg issues

[Tonerbomb]

any codes???????????

[barber782]

Error code sc285-00

[Timmytronic]

Error code sc285-00

Hiya. I know it’s been a while but I have a bad yellow out of reg on a Pro c5200 and wanted to know if it what you did to fix? I have replaced the entire Transfer unit from a working machine after I did the belt and sensors. It’s only the yellow out so will try replacing the yellow drum tomorrow.

thanks. Tim.

[Phil B.]

Hiya. I know it’s been a while but I have a bad yellow out of reg on a Pro c5200 and wanted to know if it what you did to fix? I have replaced the entire Transfer unit from a working machine after I did the belt and sensors. It’s only the yellow out so will try replacing the yellow drum tomorrow.

thanks. Tim.

dead thread grave robber.

diff machine...

start your own new thread

[Timmytronic]

dead thread grave robber.

diff machine...

start your own new thread

Seriously Phil. Get a life!

[mga]

Hiya. I know it’s been a while but I have a bad yellow out of reg on a Pro c5200 and wanted to know if it what you did to fix? I have replaced the entire Transfer unit from a working machine after I did the belt and sensors. It’s only the yellow out so will try replacing the yellow drum tomorrow.

thanks. Tim.

Colour registration problems clean id sensor if no good do laser line procession

[mga]

dead thread grave robber.

diff machine...

start your own new thread

Seriously Phil. Get a life!

Be nice gents