MPC3003 SC995-01

[digicor]

I have the 995-01, but the serial number is whats on the controller, what else could cause this, whats the fix? is there a fix?
do i need to get new NVram and matching eeeprom?
or is the controll board shot? it comes to ready for about 15 seconds then throws the 995-01
ideas please?

[tufbnme]

CPM setting error 1
Comparison of machine serial number (11 digits) and machine
identification code.
Details:
§ Machine serial number cannot be identified because of
BICU replacement or malfunctioning.
§ Machine serial number cannot be identified because of
NV-RAM replacement
machine serial number (11 digits) or machine identification code
does not match.
§ Enter the machine serial number using SP5-811, and then
turn the power on/off.
§ Attach the NV-RAM that was installed previously.

[mincopier]

Need to go into the "Super Secret" service mode to rest the serial numbers. There is a listing of three there and they all three must match up. Two of the three can be changed.

[kplow1986]

I have the 995-01, but the serial number is whats on the controller, what else could cause this, whats the fix? is there a fix?
do i need to get new NVram and matching eeeprom?
or is the controll board shot? it comes to ready for about 15 seconds then throws the 995-01
ideas please?

1. make sure u get correct cpm for this model. 30 and 35 is different controller.
2. make sure machine serial is match. goto factory mode to change.

[digicor]

ran service mode /reset143c/c re typed in the sn in that was in the last one , into the other two sections, done, im not sure how the sn got changed from the first two , from the third , but its all good now
so if yo have this problem enter service mode reset143c/ hold the c and there will be three sn slots , make sure they all three match

[GeorgeBest]

Super secret mode is ?
And in what Section can I reset the seriel number

Thx in advance

Need to go into the "Super Secret" service mode to rest the serial numbers. There is a listing of three there and they all three must match up. Two of the three can be changed.

[GeorgeBest]

HI,
What is " reset143c/c" ?? In what SP section is that?

Thanks in advance

ran service mode /reset143c/c re typed in the sn in that was in the last one , into the other two sections, done, im not sure how the sn got changed from the first two , from the third , but its all good now
so if yo have this problem enter service mode reset143c/ hold the c and there will be three sn slots , make sure they all three match

[mga]

HI,
What is " reset143c/c" ?? In what SP section is that?

Thanks in advance

This is old thread 143 is factory service mode

[GeorgeBest]

Don't know what you mean here, must get rid of the SC995-01
entering on three places? Only see SP5811-002 and SP5811-004 . . .

given me a headache ....

This is old thread 143 is factory service mode

[slimslob]

You should not have to get into Factory Service mode as long as you followed the proper procedure the very first time power was applied after changing the BCU, Controller.

Set serial number on new BCU
Open the front cover.
1. Turn the power on. SC995-01 occurs immediately.
2. Make a note of the number that is displayed in SP5-811-005.
3. Enter the number that you noted in SP5-811-004.
4. Turn the power off.
5. Close the front cover