Dislikes:
0
-
MP 6001 with exit jams
greetings.
I have this mp6001 that was giving random duplex jams and now it is jamming 014 as the paper exits 2/3rds out.
It is random but i tried different paper trays and pulled the drum,cleaned the sensor near the reg roller,all fuser sensors and had recenly change LFR/UFR
and all fuser gears.Lead edge is spot on.
It looks like the exit motor is just stopping??
-
Re: MP 6001 with exit jams
Check the guide plate between the fuser unit and the duplex unit. Its the one that flaps back and forth when you pull out the duplex unit. There is a pin on the shaft that keeps the guide plate snug when its in the close position. Sometimes the part that the plate meets with the pin cracks and causes the paper to misfeed on the way out.
Good luck
-
Re: MP 6001 with exit jams
Is there a second sheet of paper that is just exiting the fusing unit? J014 is a lead edge fusing exit jam. Fusing exit sensors have been known to fail intermediately from prolonged exposure to heat.
-
Re: MP 6001 with exit jams
it is usually one sheet 2/3rds out,no oddities and 1-2 sheets near the transfer belt.
if it didnt reset jam i thought bad sensor but it resets and will run..
I never had a exit motor go bad and i am replacing this box in 24 days when i can get into the building on a
Saturday,it s in a very busy area nr 911 museum..
-
Re: MP 6001 with exit jams
if it has 3 mil or more i would replace the transport belt. it could also be the drum seperation claw unit.
-
Re: MP 6001 with exit jams
thanks.
It has less than 3 mil
Image transport belt is what you suggest?
I am going back tommr.will pull the ITB unit and was
wondering is there only motor for fuser and exit?
-
Re: MP 6001 with exit jams
-
Re: MP 6001 with exit jams
X3 for the exit sensor.
BTW, does it happen on all trays? Quite odd but I had martinis giving wrong paper jam code but the culprit was the paper feed unit gears.
-
Re: MP 6001 with exit jams
I've had this issue also, just before i lost the client due to this problem.
I never solved it.
I've tried every trick in the book (and from this site)
Good luck!
-
Re: MP 6001 with exit jams
Originally Posted by
davel
X2 for exit sensor
is that the one wth the flag or a reflector type sensor?
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks