Ricoh pro5100 sc 569-02

[levantin]

ricoh pro c5100 error message sc569-02 have any way to fix it. thank you

[copier tech]

ricoh pro c5100 error message sc569-02 have any way to fix it. thank you

From the service manual.

SC569-02


Pressure Release Error: HP failed 3 times
Pressure release/Home position/control failed 3 times consecutively.
Monitored when the pressure release mechanism is operating.
Pressure Change: SP1-151-001 1:On/0: Off
When this SP is set to OFF, SC detection is disabled.


• Pressure release motor, sensor defective
• Feeler deformed or damaged
• Pressure release mechanism defective
• Replace the motor.
• Replace the sensor.
• Replace the feeler.
• Replace the unit.

[levantin]

From the service manual.

SC569-02


Pressure Release Error: HP failed 3 times
Pressure release/Home position/control failed 3 times consecutively.
Monitored when the pressure release mechanism is operating.
Pressure Change: SP1-151-001 1:On/0: Off
When this SP is set to OFF, SC detection is disabled.


• Pressure release motor, sensor defective
• Feeler deformed or damaged
• Pressure release mechanism defective
• Replace the motor.
• Replace the sensor.
• Replace the feeler.
• Replace the unit.

Thanks
I went through it but I wanted to know more

[slimslob]

I wanted to know more

Become an authorized dealer and then attend classroom training.

As for your current error, you might have a scrap of paper covering a contact on the drawer connector(s). I had one where the scrap was just large enough to cover one contact.

[levantin]

Become an authorized dealer and then attend classroom training.

As for your current error, you might have a scrap of paper covering a contact on the drawer connector(s). I had one where the scrap was just large enough to cover one contact.

I suspect a drying heater lift error

[Zaxxon]

You should listen to slimslob