ricoh mpc2800 with sc 533

[fshead]

HI
GOT THIS on a ricoh mpc2800 i picked up wth 30k total.
I looked thru the parts manual and cant find which fan is the IH inverter fan.
Did not see any fan wth such name to test via service mode..
thanks


No.TypeDetails (Symptom, Possible Cause, Troubleshooting Procedures)533DIH inverter fan errorThe machine does not detect the fan motor lock signal for 10 seconds while the IHinverter fan turns on.• Disconnected harness•Overload on the IH inverter fan motor• Defective IH inverter fan motor• Defective IOB1. Check or replace the harness.2.Replace the IH inverter fan.3. Replace the IOB

[anothertech]

D023/D025	SC 533	Drive Unit fan error - replace fan, #B2231332 (right side below IH inverter bd)	04/30/12
D023/D025	SC 533	Drive Unit fan error - replace IOB	04/30/12
D023/D025	SC 533	Drive Unit fan error - use SP5-804-121 to check (also called IH Coil fan)	04/30/12
D023/D025	SC 533	Drive Unit fan error - check/reseat CN 218 on IOB	04/30/12

[MIGUELMARCHENA]

FAN.pdfFAN.jpgNo hablo inglés con fluidos, pero intentaré ayudar Aunque pondré una imagen del manual de piezas MP4000, el servidor para ubicar el ventilador está debajo del panel, a la derecha., Una pequeña tapa, retírela y podrá ver eso

[fshead]

super
thank you.
my manual was limited..

[fshead]

FAN.pdfFAN.jpgNo hablo inglés con fluidos, pero intentaré ayudar Aunque pondré una imagen del manual de piezas MP4000, el servidor para ubicar el ventilador está debajo del panel, a la derecha., Una pequeña tapa, retírela y podrá ver eso

mucho gracias
excellente yo entiende ahora

[Mark Bbb]

It can also be that the machine software needs a new F.U. (a fusing reset in other words).
I cheat the reset procedure with a switch (which i learned here on this Copytechnet site).
Do you know this procedure?
Certainly with sc533 this reset procedure is very necessary, with this code, i am not sure.

[fshead]

I think you are thinking of the mpc3002 series funky pico fuse reset procedure..
This code i think is just a fan,connector or brd...
it does come to ready sometimes and I will pull back off and ck fans and connectors....
thanks

[fshead]

danm truckers moving electronics like it is lumber...............

[fshead]

mucho gracias
excellente yo entiende ahora

FAN WAS to the left of the right side door..........

[fshead]

FAN WAS to the left of the right side door..........

i meant to say fan was to the right of the right door and left of the controller..
Its odd they bent the metal brackets,fan but all outside plastic was in one piece and perfect..X MEN ??