Results 1 to 4 of 4
  1. #1
    Senior Tech 250+ Posts
    Join Date
    Jul 2009
    Location
    Den Bosch
    Posts
    476
    Rep Power
    0

    MP301 display-touch panel ?

    HI,

    This machine starts up, then press copier or scanner, sometimes it reacts, sometimes not at all
    And when it reacts, it does it only one time, then it freezes completely. . . ?

    Doubt if it is just the operation panel or maybe a controll board error ?
    I can get into Touch & LCD test mode, but from there again it freezes.

    Someone?
    Dont know what part I should order here . . .

    Thanks in advance

    gr George

  2. #2
    Senior Tech 100+ Posts CopyBats's Avatar
    Join Date
    Aug 2011
    Location
    Toronto, ON
    Posts
    128
    Rep Power
    31

    Re: MP301 display-touch panel ?

    Are all the firmwares upto date including the op panel ?
    A while ago I had one or two of these get fixed by doing a firmware update.

    Check the logging data to see if any SC codes internally.


    Quote Originally Posted by GeorgeBest View Post
    HI,

    This machine starts up, then press copier or scanner, sometimes it reacts, sometimes not at all
    And when it reacts, it does it only one time, then it freezes completely. . . ?

    Doubt if it is just the operation panel or maybe a controll board error ?
    I can get into Touch & LCD test mode, but from there again it freezes.

    Someone?
    Dont know what part I should order here . . .

    Thanks in advance

    gr George
    If it works, don't touch it.

  3. #3
    Service Manager 1,000+ Posts
    MP301 display-touch panel ?

    guitar9199's Avatar
    Join Date
    Sep 2016
    Location
    Eveleth, MN
    Posts
    1,090
    Rep Power
    41

    Re: MP301 display-touch panel ?

    If the Op Panel is "Freezing", just as an experiment try disconnecting the network cable and fax line from it and reboot the device. See if it keeps freezing up then.

    I've had more than a few of these devices that the control panel would freeze up because they were running "Power Over Ethernet" on the network, and those integrated network cards don't like that voltage being applied to them.

    If it starts working, get with their IT people and see if they can remove the Power signal from that network port. If not, you'll have to make a network cable with the power lines not hooked up, or connect a hub/switch between the wall and the machine.

  4. #4
    Service Manager 2,500+ Posts
    MP301 display-touch panel ?

    sandmanmac's Avatar
    Join Date
    Feb 2009
    Location
    Toronto, ON
    Posts
    3,885
    Rep Power
    159

    Re: MP301 display-touch panel ?

    Quote Originally Posted by safwat View Post
    Are all the firmwares upto date including the op panel ?
    A while ago I had one or two of these get fixed by doing a firmware update.
    x2 on this.
    I had the same issue recently

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-= -= -= -= -=


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here