Picture-2019.jpgHi All,
Can someone help ! As you can see in the attached file, The color pattern printed is not aligned.
Can you please direct me to fix this issue ?
Ricoh MPC 3000
Regards
Dick78
Picture-2019.jpgHi All,
Can someone help ! As you can see in the attached file, The color pattern printed is not aligned.
Can you please direct me to fix this issue ?
Ricoh MPC 3000
Regards
Dick78
Last edited by Dick78; 11-14-2019 at 02:32 PM.
If you are an end user try running Auto Color Alignment in User Tools - Maintenance. If ACA in User Tools or Auto Line Position in SP ends in an error and does not alignment or the problems returns, the ID sensor assembly is dirty. Clean it with a cotton cloth moistened with water.
Like Slim said, Try Auto Color Calibration. "User Tools/counter" --> "Maintenance" --> "Color Registration".
If that doesn't get you straightened out, then go into SP mode and execute SP 2-111 mode C first, then mode A after that. (Mode C = rough adjustment, Mode A = Fine adjustment twice).
If that doesn't get you aligned, then you will probably have to clean the ID sensors. You could also do this step First.
Last edited by FrohnB; 11-14-2019 at 09:49 PM.
Bookmarks