[SOLVED] J69 on Martini Series (MP75000, 7500, 7001, 7002, 7003)

[ricmartinho]

Hi there!

I got this one today on a MP6002, when duplexing or printing face-down. The sheet stopped at the Duplex Entrance sensor.
The inverter sensor was ok and the rest of the rollers, guides, mylars all seemed ok. Found to be the Inverter Roller that was not connecting properly with the Inverter motor.

To solve this you can adjust the position of the duplex Unit by doing the adjustment shown on the picture.
duplex.JPG

[davel]

So how is duplex side rego now?

[ricmartinho]

Afterwards I just did the registration adjustment like you normally would on SP Mode and Trimming Area Test Pattern.

Enviado do meu ALE-L21 através do Tapatalk