mp 6503 with j003 issue

[totoro]

I have watched customer load paper in the tray and they do it better than I do. It has to be some mechanical problem that i'm missing, but thanx for the imput.

[luca72]

If you only changed the separation roller, you will be back.

hahahahaha, you made me lie down, I have a colleague who does this !, change the parts individually, my boss and I always take it for a ass!😂😂😂

[skinnyb]

If you only changed the separation roller, you will be back.

Truth. Always replace the set, or it WILL bite you in the @$$

Sent from my LM-V405 using Tapatalk

[slimslob]

I have watched customer load paper in the tray and they do it better than I do. It has to be some mechanical problem that i'm missing, but thanx for the imput.

What you are missing is the rest of the 3 roller paper feed system. It is recommended the all three rollers be replaced new at the same time.

In normal operation the friction between the feed roller and separation (reverse) roller is greater than that of the torque limiter. This allows the feed roller to drive the separation roller in the feed direction. When either are worn the separation roller can slip against the fed roller and turn in the reverse direction. This causes the jam. Replacing just the separation roller usually corrects the problem for a couples of weeks at most.

[copier tech]

hahahahaha, you made me lie down, I have a colleague who does this !, change the parts individually, my boss and I always take it for a ass!😂😂😂

Same here my colleagues only change the sep roller saying “its the only roller that looked won”

[totoro]

I did not change just the sep roller. I put in a new feed unit .

[tonerhead]

Pull out and remove left side of tandem tray so you can watch the feed operation. Here is what I have done on every last one of mine. I have skinned the rollers off of the hubs and substituted these. Pickup AF030049, Feed AF031098, Sep AF032098. What I found is the pickup roller tends to be the culprit. The AF030049 with the slots tends to kick the paper forward much better than the AF030090 original. Watch it and try it.

[davel]

Pull out and remove left side of tandem tray so you can watch the feed operation. Here is what I have done on every last one of mine. I have skinned the rollers off of the hubs and substituted these. Pickup AF030049, Feed AF031098, Sep AF032098. What I found is the pickup roller tends to be the culprit. The AF030049 with the slots tends to kick the paper forward much better than the AF030090 original. Watch it and try it.

Are you thinking of MP C6503? aren't the rollers different diameters.

[mga]

Please note tray 1 feed assy isn't the same as tray 2.
Any feed problems I also start with all 3 rollers and the limiter

If machine has done 700k you should replace by the way don't waste your time replacing one roller

[mga]

Sorry guys I thought you was talking about mpc6503 feed sections are the same on MP6503 series