I changed drum and developer but I still get light quality when I take print or copy. Anybody help me please?
I changed drum and developer but I still get light quality when I take print or copy. Anybody help me please?
What about the rest of the PM parts? Did you initialise dev correctly and clean everything first, was dev roller clean.
Check that the dev and drum units are seated properly in place. If there’s too much of a gap cq will be light.
suck the whole part around the drum including led lamps, filters, replace the other parts too see the pm counter list (at least those of the drum and transfer section) also clean the scanner section. Total number of pages? There are other posts on this classic problem with similar models.
Do not suck (vacuum) anywhere near the ID sensor as doing so can generate enough static to damage the sensor. You can vacuum most of the drum frame but stay at least 1 inch away from the sensor. Use an artist's brush to remove toner next to the sensor. Clean the face of the sensor itself with a soft cotton cloth moistened with water only, anything else can damage the sensor.
Bookmarks