Hi All
I got a new fuser film unit and it comes with a fuse to reset ..
I can't figure out where to plug it ..
Any ideas ..
Thanks
E8388-2.wh.jpg
I wonder it go to this blue jumper ?
20200316_091614.jpg
Hi All
I got a new fuser film unit and it comes with a fuse to reset ..
I can't figure out where to plug it ..
Any ideas ..
Thanks
E8388-2.wh.jpg
I wonder it go to this blue jumper ?
20200316_091614.jpg
No. it does not go where the jumper is. It goes on the other connector. If you check the service manual on replacing the fusing film, it tells you which pins and which connector it goes in. If you manually reset the fuser count, you should not need the fuse anyway.
There was one code in color machine that needed fuse to get to "level 2 reset". I suppose this one could be the same but have not yet run across needing it. A good reason to hang on to fuses in case that day ever does come I suppose.
It is a 2 pin connector inside the fuser. It is typically on the plastic piece where the plug that goes into the machine is and where the rest of the harness goes along. It most likely has nothing plugged into it at the moment or it may have a fuse in it already.
As Slim mentioned, you should not need the fuse unless the machine is in a coded condition.
fuse.pdf
You only need to use fuse for SC544
Yes, I'm aware of that
I got it
Thank you so much .
2020-03-16_19-40-39.jpg
Last edited by Tech18; 03-17-2020 at 12:42 AM.
Bookmarks