hi
I just powered up a shop mpc401sr to inspect and earlier in the day came to ready and ran some test prints.
Now i recheck hours later to see how much toner it has and it codes out 1st 681-08 and then 681-39..
i swap out toner with a different and then it wont see yellow installed.
EVENTUALLY IT POPS 681-39.
I check that -39 means yellow
can i vacuum inside or will static fry the RFID brd
how long would you think getting the rfid changed would be?
it has been a while since i gutted a mpc401
Replace toner bottle. Confirm that RFID connectors and harnesses are connected correctly. If the connectors and harnesses are damaged, replace theRFID_CPU board and Harness: ANTENNA: Toner Supply. Replace the affected RFID_AFE board (KMCY). (See table below.)
Bookmarks