i have install new fusing belt for mp c8002 and it tears with worming up the machine,i didn't even print to test it,i checked the installation all is fine,also i've replaced the hot roller and same occurred,any suggestions please?
i have install new fusing belt for mp c8002 and it tears with worming up the machine,i didn't even print to test it,i checked the installation all is fine,also i've replaced the hot roller and same occurred,any suggestions please?
Did you also replace the rest of the rollers in the fuser? If you're in there you may as well.
It's 106 miles to Chicago. We've got a full tank of gas, half a pack of cigarettes, it's dark and we're wearing sunglasses.
Hit it.
What are the Part Numbers for the Belt and Hot Roller you replaced?
There's a bulletin about the "Heat Roller Assembly" where the flanges slip inside the metal sleeve and those swell up and touch the belt causing it to be torn.
New roller Part Number is D1364450, i would check and Replace this roller.
Omertà
Regards Mark
FOR TRADE AND END USER SERVICE CALLS PLEASE VISIT WEB SITE FOR CONTACT DETAILS. COVERING GREATER LONDON {UK} AND ALL SURROUNDING COUNTIES.
RICOH, CANON, KYOCERA, KONICA, SHARP, HP/SAMSUNG BROTHER, LEXMARK.
https://copierservices.simdif.com
It's 106 miles to Chicago. We've got a full tank of gas, half a pack of cigarettes, it's dark and we're wearing sunglasses.
Hit it.
Also...there are two shoulder screws either side of the fuser that hold the belt unit in.
If you mistakenly use NON shouldered screws when you rebuild it...you'll shred the belt eventually.
It puts too much pressure on the frame and runs the belt off to one side.
Found that out the hard way
Bookmarks