MPC307 registration ?

[GeorgeBest]

Hi,

Still got this problem on an MPC307, with only 6K Black on the counter.
see the example . . . First, second and third output, registration leading edge..

Did the firmware, checked fuser, ITB and registration roller.
To do an registration clutch replacement, its quite a job, can't image this on a 6K count

anyone another idea or clue before I go for the clutch . . .

Thanks in advance6E2170C8-9D32-4457-A017-B9B6E7B10E27.jpg

[davel]

Rego roller is not stopping at the right time, try sensor first then maybe clutch bad and staying on.

[aktasson]

Hi,

Still got this problem on an MPC307, with only 6K Black on the counter.
see the example . . . First, second and third output, registration leading edge..

Did the firmware, checked fuser, ITB and registration roller.
To do an registration clutch replacement, its quite a job, can't image this on a 6K count

anyone another idea or clue before I go for the clutch . . .

Thanks in advance

I had a similar problem on a A3 mpc, but same on feed direction. In my case it was the drive/motor to development unit. First page mostly was good, but the next pages on a multiple print/copy job shifted.
CHeck in sp (test pattern) with copy mode if this happen same for each pcdu color unit.

[mga]

Hi,

Still got this problem on an MPC307, with only 6K Black on the counter.
see the example . . . First, second and third output, registration leading edge..

Did the firmware, checked fuser, ITB and registration roller.
To do an registration clutch replacement, its quite a job, can't image this on a 6K count

anyone another idea or clue before I go for the clutch . . .

Thanks in advance6E2170C8-9D32-4457-A017-B9B6E7B10E27.jpg

Looks like Registration clutch problem not to hard to replace

[black]

Fixed it replacing regist. clutch.

[mga]

Fixed it replacing regist. clutch.

Well done good job thank you for letting us know.