Savin 5055 / Ricoh 6054, "Replace Fusing Belt Unit"

[Oystercopy]

We are new to this machine, and we've looked in the SM, but can't seem to find the simulation to RESET this indication, after replacing the part. Can anyone help?

Thanks!
OC

[CopyBats]

What's the usage on the fuser unit ?

We are new to this machine, and we've looked in the SM, but can't seem to find the simulation to RESET this indication, after replacing the part. Can anyone help?

Thanks!
OC

[skinnyb]

We are new to this machine, and we've looked in the SM, but can't seem to find the simulation to RESET this indication, after replacing the part. Can anyone help?

Thanks!
OC

Just reset the pm counter in service mode and the message goes away. I have done that before when I didn't have one in Stock to get it running till I could get back with a new part.

Sent from my LM-V405 using Tapatalk

[sandmanmac]

We are new to this machine, and we've looked in the SM, but can't seem to find the simulation to RESET this indication, after replacing the part. Can anyone help?

Interesting...if that was truly the case, then you would see that the SP mode you need to run is the VERY FIRST LINE under "Heating sleeve belt Unit", in the "Replacement and Adjustments" section

[anothertech]

Interesting...if that was truly the case, then you would see that the SP mode you need to run is the VERY FIRST LINE under "Heating sleeve belt Unit", in the "Replacement and Adjustments" section

They probably don't know how to get into "simulation"

[Hoosierdaddy]

Do you smell what I smell?

[copier tech]

Do you smell what I smell?

Yes, smells like "end user"

[copier tech]

They probably don't know how to get into "simulation"

This is explained in detail in the service manual.

[Oystercopy]

Yes, smells like "end user"

HMMM.... I realize many of you don't know me, but I've been doing this longer than most of you. I sent another tech out to this call, and the guy is an ace on most of the Ricoh boxes, but as I said, we don't know this machine and I don't know what service manual he was referencing.

BUT I HAVE noticed a lot of SNARKY, hateful comments on this board as of late, and I think if you're going to act all superior about EVERYTHING, you really should take a look at yourself and your own shortcomings, FIRST... sort of like the severe entitlement issues of the Black Lives Matter movement, and the havoc they're causing across the country, because they simply don't know who they are as human beings, nor their place in society.

I was on Smarka for many years before this and I never encountered such a disdainful culture of people there.

I want to continue to be a part of helping other technicians when needed and receive help when I ask for it. But this useless "better than thou" attitude does no one any good.

OC

[FrohnB]

Two ways to Reset;
SP 3-701-xxx "Manual New Unit Set" (choose the parts you want to reset) then cycle the machine.
SP 7-621-xxx "PM counter reset" (choose parts to reset counts on), don't have to cycle machine with this one.