Ricoh mp2501

[Jama]

Was the first printout (or copy) after your PM good are - right away - too light?
Were the printouts also light before your pm?

All too light

[granata]

Screenshot (38).jpg
hi,check A267-3440

[Jama]

Screenshot (38).jpg
hi,check A267-3440

ok,

[Jama]

A267-3440 this could be totally plain

[Jama]

What about the toner?
OEM Genuine?
My bad just noticed oem

Sent from my SM-G960U using Tapatalk

yes, original

[mga]

Did you replace parts and setup according to SM

Regardless of toner bottle the first 20 or so prints should be ok as fresh developer.

Is the dev unit turning

[StephenB]

You did not say...were the prints ok before you did this work ?

And I'm going to throw this out there...did you put the developer drive gear back on the rear side of the PCU ? And check that the drive (spring loaded) on the copier side is moving in and out freely.

[slimslob]

And I'm going to throw this out there...did you put the developer drive gear back on the rear side of the PCU ? And check that the drive (spring loaded) on the copier side is moving in and out freely.

I have had the damned coupling fall off while sliding the PCDU back into the machine.