Dislikes: 0
Can ping back and forth, even see the machine thru Web Monitor but can't print to it. Made sure everything was reset to original settings when it supposedly worked, tried multiple setting variations on Fiery and C5100. Tried new cross over cable. All lights on for network card connections. Been a while since I've had to do a Fiery connection troubleshoot. About ready to suggest client remove the Fiery and use the internal set up if possible. Any suggestions?
Can you web into the fiery?
Any error on the fiery?
Yes.Originally Posted by bsm2
Error: Check copier power and cable connections
Reboot fiery and turn off copier boot the fiery up first than wait 3 mins and turn on the copier
Sounds like its not synced
I've tried that several times, probably never waited 3 minutes, but I'll know in the next 5 minutes if that works.
No, that didn't work.
ok turn off copy boot fiery until fiery is ready than turn on copier.
Tried again, no luck.
Here's the thing that's odd IP Address for Server is 192.168.1.140
Copier is set to auto obtain but the IP address comes up 169.254.139.173 with Subnet mask 255.255.0.0 which I believe isn't correct.
On the older Fiery's the IP addresses would be the same and subnet would be 255.255.255.0, which at one point this one was.
169 means no network connection
Both the C5100 and the Fiery have 2 Ethernet ports. The gigabit port is for connection between the Fiery and the C5100 only. You may have one or both of them connected wrong.
Posting Permissions
Thanks: 
Likes: 
Reply With Quote
Bookmarks