Hi everyone, I have a Ricoh pro c5110s, and this printing fails, can someone help me? I don't know what it can be, thank you very much.
Hi everyone, I have a Ricoh pro c5110s, and this printing fails, can someone help me? I don't know what it can be, thank you very much.
Hallo,
Can you print off a PM counter list and upload it please?
Bands look the same in all 4 colors. Thank you for your supportive response. Attached as requested!!
Hello again,
That's the commissioning status, not the PM counter. When you first go into SP modes, there's an option that says something like "PM Counter / Manual New Unit Set" on the same page as System SP, Printer SP etc. Go to "counterlist printout" in there and upload that one please.
With the banding affecting all colours could be ITB, PTR or fuser, but we'll see when you upload that file.
sorry !! uploaded again.
On the Commissioning report I am seeing a lot of 0 remaining item that are showing as having been replaced. To me that indicates a production machine that is being highly under used and doing a lot of very small jobs for a production machine. I have a feeling that your toner consumption is higher than what is specified in the Product Support Guide and you are using a lot of waste toner bottles.
My client has a small printing company and does not make a large number of copies, he has a very good print quality in full lengths and photographs, but these marks come out in half tones, I don't know the causes.
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
Are your test prints off the engine or the fiery? i ask because i had a similar banding issue with a customer running a gray background you could see a magenta band it it ended up being a setting in the fiery that was causing the issue.
Run the DEMS as mentioned before Check the ITB belt guide mylar, it gets toner build up.
Almost looks like your getting shock or jitter. lots can cause that especially in the fusing and transfer area. Especially if running a coated or thicker paper.
Bookmarks