Client broke transfer roller section and we replaced it from a donor machine. All seems fine except giving us an sc204 with the roller installed. Without roller it’s fine but jams. Any ideas?
Client broke transfer roller section and we replaced it from a donor machine. All seems fine except giving us an sc204 with the roller installed. Without roller it’s fine but jams. Any ideas?
Are you absolutely sure that the error code is SC204 or is that a typo? To my knowledge there s absolutely no relation between the PTR assembly and the polygon mirror motor.
There was a bulletin forever ago about the lower springs causing this. If you take the ptr out no error. So would we still not get a polygon error if the ptr were removed?
Then why are you not doing what that supposed bulletin says to do to correct the problem.?
Thanks. Yes I have and just was having a hard time lining up those springs. I did and it works and so yes an sc204 does have to do with ptr
I wish. It’s been years and years and I only had the memory of it in my upstairs rattle cabinet. Getting too old for these things
Thanks for that worthless garbage. Enjoy your insulting posts. I am in a remote area and most of the time I would have to travel 70 or more miles to grab the pdf. Some decent folks on here help quicker than I could drive to get them. If you don’t want to help, don’t, just go about your miserable existence and be happy.
Bookmarks