FUSER UNIT RICOH MPC2003

[mrwho]

+1 they all will work I carry one number and use as and when any 03 series just swap bottom fuser cover or take pin out out copier it will work

You're talking about just the D150 sleeve, and not the entire fusing unit, am I correct?

[mga]

You're talking about just the D150 sleeve, and not the entire fusing unit, am I correct?

Yes I carry the d150 sleeve assy but all the other parts for the metis series ie mpc2003 to 6003 are the same part numbers apart from the sleeve and the bottom cover on the fuser assy

[sandmanmac]

Hello Everyone,
I have a customer who uses Ricoh mpc5503 and the Fuser Unit sleeve got damaged. Trying to swap fuser unit from 2003 to 5503 unit doesn't fit in. What could be the problem??

My guess is it got damaged from all that " counterfeit" 300 g/m2 paper.
RICOH MPC5503

[Pixtech Frameworks]

No, this is another customer whose 2003 has a PCB issues, so trying to interchange fuser unit from 2003 to 5503 doesn't fit in.

[Pixtech Frameworks]

I thought of these also. I my thought is if the D150 assy lamp will not blow since am interchanging from 2003 to 5503 which is higher model.

[skinnyb]

I use the D150 sleeve across the board, all the other parts are interchangeable like mga has said. I even had a rebuilt 45/55PPM unit that I put in a 3003 a while back, just swapped out the bottom plate and it has been running fine for over 6 months now. That said, the 2003 sleeve unit heater I would be afraid would not put out enough heat on a 55ppm device and code out on you.

[Pixtech Frameworks]

I will just swap sleeve then because swapping D150 assembly to 5503 is a 50% chance, so to avoid throwing up codes and customer calling all time.
Thanks for the clue.

[Debs1964]

I will just swap sleeve then because swapping D150 assembly to 5503 is a 50% chance, so to avoid throwing up codes and customer calling all time.
Thanks for the clue.

D150 is the correct part number for the 5503, this is the higher wattage part, and can be used on all 03 models