scanner image whacked

[Gift]

okay thats the ticket, it was way bent down, and i bent it back, good quality, but, the scanner is definitely loose in the corner, i can just lean on it and it moves down,, any fix for this? i guess if the client doesnt do a butt shot it should be okay
Attachment 53051Attachment 53052Attachment 53053

You can use that scanner support thingy for transport if there's no finisher / internal stuff installed.

Imgur: The magic of the Internet

If the installation was made properly this part hasn't been dumped but clipped on the inner side of the front door.

It's also possible to loosen a bunch of screws between the scanner and machine frames and re-tighten them while lifting up the front/left corner.

[Mark Bbb]

You can use that scanner support thingy for transport if there's no finisher / internal stuff installed.

Imgur: The magic of the Internet

If the installation was made properly this part hasn't been dumped but clipped on the inner side of the front door.

It's also possible to loosen a bunch of screws between the scanner and machine frames and re-tighten them while lifting up the front/left corner.

Jep, that's the one!
My bet is on this fix

[tonerhead]

Glad you got it figured out. I haven't had to do a "chiropractic" adjustment on a copier for years. Customer must have really pushed down on the corner of machine

[luca72]

I have also seen lazy customer employees lean on the front of the machine while they are using it.

I always lean there too ... but then I straighten it (LOL)