MP C2503 no pick up

[UNICORNico]

Are there any magnetic clutches involved in the paper feed drive? In case there are I'd take a look in that direction (and check out that tray hint of course).

I hope the firmware is..... aahh other people are faster than me

I thought the same thing when I remembered a similar case with a model 02.
It turned out that the clutch/motor that drives the paper collection unit remained activated, when the shaft should rotate freely.


When I hit him a few times with the handle of the screwdriver, he seemed to break free, but I change it for another and notice that he had some rust.
drive unit.jpg
Maybe in this case, it is not so. But it may be something related.

[Gift]

Ah it's probably the same drive they use in the MPC3003 so this should not be the issue.

I had a lot of fun with clutches during the Aficio 350/1035/2035 periods......

[luca72]

Ah it's probably the same drive they use in the MPC3003 so this should not be the issue.

I had a lot of fun with clutches during the Aficio 350/1035/2035 periods......

i based on my calls on our metis fleet, it would seem that this is "top" of the problems, just behind sc672.. LOL

[Gift]

i based on my calls on our metis fleet, it would seem that this is "top" of the problems, just behind sc672.. LOL

Does it happen with the "non budget" metis, too (MPC3003 and higher)?
I can't recall I've dealt with this before. I wasn't really a friend of this series when it came out but all in all I'm quite happy with it.

SC672 on the contrary, yes this happen to us every now and then, too

[GIUBOSS]

Try swapping with the other paper tray: 54. D1492773
PULLEY: PICKUP: MECHANICAL ROLLER CLUTCH

[luca72]

Try swapping with the other paper tray: 54. D1492773
PULLEY: PICKUP: MECHANICAL ROLLER CLUTCH

He says that have replace the pick up station assy. With another.

[GIUBOSS]

He says that have replace the pick up station assy. With another.

Forget about it

[copier tech]

I went back with a paper feed drive unit I try lift motor then ran 500 duplex prints without a single jam. This was made of of about 10 runs & I opened & closed the tray to try & replicate the issue again hopefully one of those units was the cause.

[GIUBOSS]

I went back with a paper feed drive unit I try lift motor then ran 500 duplex prints without a single jam. This was made of of about 10 runs & I opened & closed the tray to try & replicate the issue again hopefully one of those units was the cause.

Don't trust this: 24.AW500040
(x2)
PUSH SWITCH: SW
1AG-550: 10MA