MP5054 fault contr.board

[GeorgeBest]

Hi

Seems that the netwerk interface is out after a power loss in then building
Interface on board, is the controll board compatable with the MP3054 ?

thanks in advance

[GIUBOSS]

Hi

Seems that the netwerk interface is out after a power loss in then building
Interface on board, is the controll board compatable with the MP3054 ?

thanks in advance

I think they are different

[slimslob]

According to the parts catalog they have different parts numbers.

[KeviM]

I don't think they are compatible. I think 2554 and 3054 are compatible.

Also I think 5054 and 4054 are compatible.

All the best friend

[slimslob]

I don't think they are compatible. I think 2554 and 3054 are compatible.

Also I think 5054 and 4054 are compatible.

All the best friend

You forgot the 35 in the slower group and the 60 in the faster group. Looking at the Product Support Guide there are a lot of things that are different.

[kleankopy]

Ricoh Control Boards are all model specific and that is why they have different part numbers.

[slimslob]

Ricoh Control Boards are all model specific and that is why they have different part numbers.

And even within the same model they can be feature specific.

[kleankopy]

And even within the same model they can be feature specific.

I have never seen that before; we always use the same nvam chip and its always worked. We have had to replace over a dozen control board in last week due to Ian and Power surges and it just taking out network side. Made a bunch $ but donated all profit to

www.FloridaDisasterFund.org or text DISASTER to 20222. Please help if you can.

[slimslob]

I have never seen that before; we always use the same nvam chip and its always worked. We have had to replace over a dozen control board in last week due to Ian and Power surges and it just taking out network side. Made a bunch $ but donated all profit to

www.FloridaDisasterFund.org or text DISASTER to 20222. Please help if you can.

The NVRam chips are the same but not al the controller boards are. In the parts catalog for the 5054 there are actually 6 different part number shown. Primary difference is which region of the world they were produced for.

Older models where the SPDF was an option when ordering a new machine, the reason you could not order it as an add on to an existing machine was it required a different controller for the CIS to connect to.

[luca72]

Hi

Seems that the netwerk interface is out after a power loss in then building
Interface on board, is the controll board compatable with the MP3054 ?

thanks in advance

they are all different ... if not what is the taste?...LOL