RICOH MPC 307

[esvesdin]

And what about kind of driver/connection? WSD install is always bad.
Use appropriate Ricoh driver for model and connectivity.
It's not the machine.

connection is by IP adresss i'ts not by WSD Port and driver is PCL 6 from ricoh page
greetings

[tsbservice]

connection is by IP adresss i'ts not by WSD Port and driver is PCL 6 from ricoh page
greetings

OK then I would probably do some machine reset, just in case.

[sandmanmac]

It's not driver , I checked everything in detail and I'm using PCL 6 for a very long time so I'm pretty sure it's not driver
greetings

I'm standing my ground.
Try removing the driver....and entire driver package. Reinstall, and reconfigure.
The issue is on the PC end.
Have you tried another PC/ laptop or even your phone?
Heck, even Try a totally different driver. For example, PCL5c or even one for another machine like MP C305 or C306 (It's all PCL after-all)

[anothertech]

Look in User tools, Machine settings, Printer. There is a setting in there that can be set to one sided or two sided.

[esvesdin]

I'm standing my ground.
Try removing the driver....and entire driver package. Reinstall, and reconfigure.
The issue is on the PC end.
Have you tried another PC/ laptop or even your phone?
Heck, even Try a totally different driver. For example, PCL5c or even one for another machine like MP C305 or C306 (It's all PCL after-all)

I tried from another computer , even with another O.S. ( win 7 and win 8 )again the same , problem is there.I like the idea of an older driver and mobile aplication . I'm gona test it on monday olso I'm going to try with universal driver or maybe to see if there some firmweare update
greetings

[esvesdin]

Look in User tools, Machine settings, Printer. There is a setting in there that can be set to one sided or two sided.

I check that setting it is o.k that not the issue here .
greetings

[keithxxiii]

Have you tried printing configuration page and see the behaviour of it? If it is the same, then must be from the printer. Maybe an SP mode or a Bit Switch.

[esvesdin]

Have you tried printing configuration page and see the behaviour of it? If it is the same, then must be from the printer. Maybe an SP mode or a Bit Switch.

yes test page also make two passes
wich bit switch did you mean?
greetings

[slimslob]

What is SP 5807-001 set to? It should be 3 for Europe. In some Asian countries they duplex everything.

Also check SP 5195-001 is set to 0. Set to 1 could cause face up exiting.

[esvesdin]

What is SP 5807-001 set to? It should be 3 for Europe. In some Asian countries they duplex everything.

Also check SP 5195-001 is set to 0. Set to 1 could cause face up exiting.

in my case exiting face down
greetings