Clear Transfer belt replacement message MP C4503

[Samanator]

I need to clear the 'Transfer Belt Replacement' message on a MP C4503.

How is that done?

Thanks in advance for the information.

[slimslob]

Follow the replacement procedures in the service manual.

[Samanator]

Thank you slimsbob.

If I had a service manual, I certainty could do so.

However, I do not wish to replace the transfer belt, I just wish to turn off the message.

[mikadonovan]

SP mode. If there is a tab that says PM counter/New unit set, do it in there. If not, go to system>data log>pm counter reset.

[slimslob]

Thank you slimsbob.

If I had a service manual, I certainty could do so.

However, I do not wish to replace the transfer belt, I just wish to turn off the message.

PM me with an email address.

[anothertech]

Funny, I don't recall ever seeing that message on one of those machines.

[slimslob]

Funny, I don't recall ever seeing that message on one of those machines.

There is a SP setting that can be used to Enable or Disable PM due messages. We usually disabled it and just depended on monthly meter readings to determine when a PM was due.

[emiliorsg]

There is a SP setting that can be used to Enable or Disable PM due messages. We usually disabled it and just depended on monthly meter readings to determine when a PM was due.

If my memory serves me correctly, I think that in those models it is deactivated from factory.

[copier tech]

If my memory serves me correctly, I think that in those models it is deactivated from factory.

Yes this is off by default.

Enter SE mode on the first screen choose PM counter you can disable the message here.

If you don't see this option you can update the firmware to show the PM counter page.

[luca72]

If my memory serves me correctly, I think that in those models it is deactivated from factory.

only the sleeve of the fuser, are activated