Ricoh 2238c offset printing. squeed

[zflash7]

On the page it raise to the top. from bottom of page it is say 10mm on left and rises to 14mm on right of page.I changed the transfer belt. and reset the maintenance counter and line adjustment. and so forth, I hope I did correct. But it still prints squeed. Re:Paul

[Lagonda]

I've got a little confused, Zflash, by "transfer plastic" do you mean the image transfer belt"? Did it skew the image before you changed the belt?

[zflash7]

yes the belt. No it was set correct on the page. b4 the belt was replaced.

[JustManuals]

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


Paul@justmanuals.com

[ptrflrs]

check if the "music" or belt sensors at the top of the belt -just above and to the left of the black pcu are clean there is a metal shield that covers them when the belt is out then run your color calibration in user tools/counter//maintenance

[zflash7]

thanks... ptrflrs.... I will next day off. It it square on the colour prints only the black n white copies seem to be out of line, I'll get back to you.. thanks again. cheers