how can I do system software for the color controller E-22B??
my color controller E-22B is not booting but I have some green light inside on the mather board.
thanks,
how can I do system software for the color controller E-22B??
my color controller E-22B is not booting but I have some green light inside on the mather board.
thanks,
Which MFP do you have it attached to? NP C6502/8002 or Pro C5100S/C5110S? What exactly is the Fiery server doing: not turning on, not booting Linus OS or not loading fiery software?
No recent experience with Fiery but you should have access to system software and read the manuals.
Hi! Any update on this? I had the same issue 2 days ago... then I changed the ram to the other socket and it start working. Yesterday it stop working... I replaced the ram but I still dont have any response from the Fiery. It turns on but there are numbers in the back display.
I configured the machine to run with the embedded controller. But I need it to run with the Fiery.
Hi all! I corrected the problem. It was initially working erratically and then ended just turning the lights inside and not the rear display. I was able to correct it! I observed that the mother board was full of dirt, I removed it and cleaned it using alcohol 91% with an spray. Then let it dry and after an hour finished drying it with a blower at a very low temperature. I assembled it and it start working!
Just a hint.. some here will tease and say you should put in microwave...PLEASE DON'T!!! But Welcome and glad to see you got it cleared... most times a fiery isn't really needed .. just a way for sales to make bigger $$$. Increase ram.. format Hdd properly. And you should be GTG. Unless you are doing REALLY high content graphics production.
Again congratulations!
Sent from my SM-G960U using Tapatalk
Bookmarks