Hi all,
We had a dead SP 4510DN, I replaced the power supply (brand new) & machine now powers on but throws SC 547-02.
I fitted a new fuser, performed SC fuser reset but the error won't clear.
Old fuser works fine in another printer.
Any ideas!?
Hi all,
We had a dead SP 4510DN, I replaced the power supply (brand new) & machine now powers on but throws SC 547-02.
I fitted a new fuser, performed SC fuser reset but the error won't clear.
Old fuser works fine in another printer.
Any ideas!?
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
Could be an out of box failure of the "new" PSU. SC 547-02 is Zero-crossing error (bad relay contact).Damaged fusing relay (open contact)
Failed fusing relay drive circuit
PSU fuse (24VS) blown
Replace the harness.
Replace the Engine Board.
Replace the PSU.
Replace the fuse.
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
I think the manual meant to say fuser.
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
Bookmarks