Clean or replace cyan developer unit
Type: Posts; User: xcopytech
Clean or replace cyan developer unit
XC power unit is 110V. XE power unit is 220V
105K22921 is 110V
105K22911 is 220V
Why do you think that Xeikon toner is compatible with Xerox
You can download it from xerox site
No, there is no option to print at dcp700 without fiery or any other print controller (creo or ffps)
Disable toner and drum in dc131 nvm read write
Replace flexible print cable between ROS and MCU and try to get service manual
I even think that dc100 toner do not have even developer in toner mix.
Old machine from 1999.
You can not use that toner in any newer xerox
Docucolor 100 or 1000?
Xerox d136?
Flexible print cable between ROS and MCU
You can print on c550 even without fiery.
Also you can change fiery ip address over machine, you do not need fiery admin password for that
What kind of problem you have?
Print quality or paper registration?
Did you follow service manual procedure, measure voltage on p/j 766 pin 1 and pin2
If you have same problem for all colors on internal test print then check back up roll in ibt assy or replace ibt assy
Did you flash SD card with new file from xerox or with image from another machine?
What software level have you tried to install?
Power off proxy settings in tools
Print single cmyk color at 30% over page and post pics here
Try pws altboot
If color band is single color then check drum for that color
You can swap drum for colors to see will problem stay on same color or will go with drum
What kind of problem you have?
Your pic is low quality so I can not see anything
How do you think to get help without main informations.
Model?
Paper type,?
Paper size?
Did you change any parts?
Try with usb port on back side of machine
Did you restore new sd card image to sd card?
Did you perform special altboot with full software dlm file and with special swup files?
5 replace sd card
Perform special altboot with full aoftware dlm file