Make sure you're using the Fiery USB Prep Tool to load the software on the USB.
Type: Posts; User: InterfaceP
Make sure you're using the Fiery USB Prep Tool to load the software on the USB.
Probably replaced the card
I have a non-expiring Maintenance/Diagnostics tool for the PCUI
DM me if you need the software
DM me if you still need this
If I'm not mistaken its the Toner CRUM chips and not the V80 that's causing thius.
C70 customer has that the K toner isn't fusing on any paper weight, and only the K, CYM all fuse as they should. Swapped the fuser, increased the paper weight and none of these solutions have given...
I've purchased plenty of things from him over the years and have never taken issue with it, conversely I have sold thousands dollars worth of Fiery Software on here also.
In my opinion you should...
How long does it typically take to preform "Belt Edge Learn"? Never really needed use the DC much but I have a V180 that wont stop throwing a 42-327.
Swapped IBT assemblies and MCU to no avail and...
If you are required to do a DOT format which is required by law if you are reselling, you need a special machine that will completely over write.
Hey everyone im getting a 024-371 and have changed LVPS 1&2 with no postiive result. Also swapped the ESS and MCU from a known good. Also shows "Unknown" on the spash screen.
Looking for an ESS...
Make sure the BUR nose isn't broken where is connects to the fly wheel
I have it uploaded to my server and can send you a link. PM me
It's completely different and probably wont fit.
If the toner chute's filling up then its not the dispense motor. Check the developer drive for functionality
Which LVPS did you replace? Versants have 2
Check the Half Tone test prints at 60% to see if there are any deletions due to a dirty ROS. This would cause the color registration to fail.
I have a 800/1000 Non-expiring Diagnostic tool that I can install on your PCUI remotely.
PM me if your interested.
It beeps because the RAM in missing. Check the LED display on the side, when working properly it should read "00" if it has another # post it and I will tell you what the issue is.
Reload software
Typically you need to be on contract with Xerox as everyone has stated but.... I have one that's non-expiring and can install myself without Xerox. I sent you a PM.
Remove the pre-registration assembly and look for a small piece of paper stuck inside somewhere
They may be too large
With all respect, I have read this 4-5 times and I cannot determine what your problem is.
Fiery software for the 77xx is extremely rare but not difficult to install as Phllis B (negative Nancy) has indicated, he has obviously never done it.
I have it uploaded to my server if you need...