dont have one of these but maybe storage wise since these are old, the contacts on the printhead or contacts inside the printer may have oxidized a bit. Like good old Nintendo NES carts, you needed...
Type: Posts; User: canucktfi
dont have one of these but maybe storage wise since these are old, the contacts on the printhead or contacts inside the printer may have oxidized a bit. Like good old Nintendo NES carts, you needed...
This is just an issue with the adf loaded sensor flag. When you load paper into the adf, it should hit a plastic flag that then triggers the optical sensor for it to be loaded or not loaded.
Most...
Just run the FULL calibration again and see if it aligns properly. If not, reman drum, crooked drum unit etc. Check which supply was last changed and that might be the issue but a 5 minutes full...
Be aware on newer HP firmware, the full path must be entered and domain/user has to be used for scan to network to operate properly.
This was on a pagewide firmware update but should be the same...
Yup, bad cap in the LVPS. Had a T654 fan turns on, no control panel lighting up. Had some other parts on hand anyway and tried them, HVPS and LVPS. My old LVPS also has the same issue. But only saw...
even better, found it on HP's public FTP site.
samsung, HP firmware etc.
ftp://ftp.hp.com/pub/softlib/software13/printers/SS/HDD-UI-Recovery/...
X7x00_series_V11.01.08.03_FS_V15.02.06.21.15_HDD
X7x00_series_V11.01.08.03_FS_V15.02.06.21.15.ehd
Either through Samsung GCSN or HP CSN since they took over Samsung's printer/copier devisions....
I have worked on a few cm6040mfp, same drum units and I have also seen the same issue, out of 6 drum changes, all OEM K drums. 2 have been defective with those same results, no black print.
Same...
Canon Imagerunner 5020 part for corona transfer unit
I recently serviced a IR5020. They had broken off the 2 electrical contact pins on the corona transfer unit. There are 2 posts that are at the back of this unit that mate with the copier's back...