Problem solved. The reason was the A0G5H16000 board. Thorough cleaning helped. Thanks for help.
Type: Posts; User: sonypoland
Problem solved. The reason was the A0G5H16000 board. Thorough cleaning helped. Thanks for help.
Thanks, I'll check it out next week.
What was the reason . I have the same problem in 1051 please help.
Yes, with little experience.
Hi. There is error j21-01 and j21-51 after changing the drum. The page stops in the middle of the transfer belt. First it's j21-01 and I have to take out the page. Then there's the j21-51 error. ...
Until I changed the drum, everything was fine.
Bizhub 1051. Installed New drum. Shows J21-51. The page stops in the middle of the transfer. I have to turn off the machine to clear the error. Drum sensors clean. Do you have ideas?
The machine has been repaired. I replaced High voltage unit / 2 (HV2). (Part used from BZ 1050) Thanks to everyone for your help.
I disassembled and cleaned the parts. nothing helped. I need to look for parts to replace them.
Ok. I check this Tomorrow. Thx.
Wysłane z mojego EVA-L09 przy użyciu Tapatalka
Do you mean electrode attachment?
The card stops in front of the lower electrode. Toner sensor clean. After removing the electrode the same situation. Maybe someone has ideas about what happened?
Did you fix this problem? I have in 920 pro sc 28-04.
Of course ADU. Thanks for the help :)
Issue fixed. The reason was the sensor on the fuser PS2.
Did you fix the problem with J31-02?
I am a user with a very long experience. Info- J31-02. Lower level M4 and pull aut ADF unit. (when Feed down)
I want to make sure before buying this part. In my machine the paper leaves the fusing but not entered the paper exit unit. One detail - Face down - stays in fusing and additionally information...
Hi. what part exactly was the cause of the failure? I have the same in 920 pro.
Printing is still bright. I checked the recommendations from the post. The image on the drum is bright and there are traces of the developer on the drum. Now again, the new developer is transferred...
Drum unit cleaned. Codes switched to operation without a bottle of used toner. Information - "Toner collection box is full" - deleted. One sided printing super clean ideal. Other side duplex perfect...
At the end of the white tube on the back there is a black tube piece without a stopper. Maybe need to disassemble and clean the wires.
The toner drips heavily on the bottom electrode.
I cleaned...
Hi.
On the BIZHUB 920 Pro machine the information appeared - Toner collection box ist full.
Is there a container in this machine?
I can not find him.
The machine works but...
OK thanks. I will check it tomorrow.
Hi. There was a failure. There were suddenly bright printouts. It turned out that the developer was out. Then I exchanged the developer. Drum. The printout is still very light almost invisible. HV...