Did you unzip the file onto the USB?
Type: Posts; User: CopierTechofOmens
Did you unzip the file onto the USB?
Is the Drum rotating?
sim 6-1 and watch everything rotate
Bypass Harness (Jumper)
Part Number 600T02261
Or If not available
Make one with 3 Paper Clips.
PJ151...
Trying to help out another tech. Any thoughts?
Accessories
PF- 707 - Paper Feeding Cabinet
DF 626 - Reverse Automatic Document Feeder
IC 602 - Image Controller
UK 104 - Upgrade Kit
FS 612 -...
Firmares only available from Sharp dealers
See if the bouncing knocked the heat sink loose on the SBC.
Registration Sensor issue
2KLCSS? What do you need for it? Power supply?
The machine comes with scanning by default.
Does it list Network Scanning on Config Page?
If the Button is missing from Display you can add it under Services Tab in Admin settings
Reseat the black HDMI-cables from the Fiery to the IOT. The cable for the yellow channel is used as a communication cable between Fiery and IOT, if this cable isn't connect properly, the Fiery will...
What options do you want?
Will it print a configuration page?
Network Scan, Scan to email?
Probably, you just need to setup the network via the Admin settings, and configure via Web UI....
Mine says: 303-355 Power On Self-Test failure detected during the NVM Integrity Test.
Which only happens if multiple failures of HDD and SD card happen and the backups are lost
The boot loader status is: SD module initialization done. SD Card or Ram Fault
OHCF Shift tray fault. Bearing jumping of the slot where it is supposed to be held (PL 29.3 item #12). Possibly
HDD Write issue
Reload Software, Replace HDD, Replace ESS PWB
Check the Registration upper chute for paper cuts, catching the paper. Also the wiring harness to the reg sensor can break due to tension and opening 2B.
Its from the 455. Just trying to help.
We can always lay golden eggs. Sometimes they're just brown logs with gold spray paint
Dip switches on the MFPC PWB to enable CN Update
48494
Which firmware did you load?
0303y1A0?
It was supposed to correct that issue
Reseat the interface cable between the DFE and the IOT
Refer to the latest Software Release Notes to ensure that the latest software level located in the software matrix is loaded in the ...
062's are errors in the scanner area. Check all connections and reset the NVM, and or reload software if nothing else makes sense
No extensions on the files?
2GB or less flash drive?
Did you plug the USB into the rear port?
When you turn it on the verify that the LEDs come on the Control Panel for a short time?
There are 2 one-way clutches that weep oil and can slip on each feed assy. Also check to see if the trays are lifting to the correct position.
Is the machine pre 9/14? The main drive and toner supply clutch have been updated. If you've checked all the mechanical then its electrical. I.E. Wiring harness, PCU
There’s a little arm on the bottom of staple cartridge that actuates the sensor. Could be missing on the cartridge