Only authorised personnel can have access to firmware
Type: Posts; User: alfpanasonic
Only authorised personnel can have access to firmware
there is a change of factory, but a new unit of transfer may already be changed. If so, when the machine is in stabilization image, you must open the front door to reset the pressure of the units
May be some unit image, you must chek
1301 = Misfeed at tray 3 feed section Tray 3/4 horizontal transport unit
Check the system paper and sensors
It is considered paper A3+ all the papers above the A3, are the information available on various Internet sites
Konica Minolta, Develop and Panasonic.
I use cygwin but don't work in VISTA.
Any ideas?
Thanks
if the fuse is burned the firmware does not solve anything :)
I have this code in a 250.
The problem was the Power Supply, chek the fuses on it
I have a similar problem and the trouble was the laser unit
Code Function Possible Cause(s)
E2- 01 Lift Motor Rotation
(1st Paper Tray)
1. Level Sensor connector disconnected.
2. Level Sensor defective.
3. Lift Mechanism defective.
4. Lift Motor...
Can you send me the firmware?
Error code c8103?
Any help?
This problem is solved?
Anything else?
After this day's the problem is solved,
It's a fuse in Power Supply.
Home position sensor is ok.
I think that may be the scanner motor or PWB assy (control motor, sensor, lamp).
I'm waiting this spars parts.
Thanks
The lock in in position
Utility Stop 00 Stop 01
I have this abort Code:
Abort Code 0X00DC0652
Any sugestion?
I have also this problem and after some tests the problem was in the paper cassette that it's broken
Yes I know how to upgrade the firmware, personally i use cygwin and have all firmaware.
How i am curious, I wait for the tip
I need firmware for Panasonic DP-3030.
Any help?
I think that is the fiery
I try in another fiery and the result is the same.
I report to the factory and i am waiting.
To reset the admin password:
1. Enter Service mode by pressing the Utility key then the Details button followed by pressing stop 0, 0, stop 0, 1.
2. Press stop, 0 then Clear to access the admin...
This is a example of the problem