Not yet!
Type: Posts; User: Bicyclerepairman
Not yet!
Optional tray 2 for this machine codes out when paper level gets low. Fully loaded will lift and display paper set. With maybe 1/4 full it will lift but code out with 502.
Have replaced tray, which...
This code is on an MJ1111 finisher attached to a 8508A. Noticed the buffer guides hesitating and not aligning equally front and back. Manually moved guides and noticed one of the buffer guides had...
I've had an issue with these sensors units where the harness wire was pinched causing a color registration issue. Not sure if it threw a CA00 or CE40 but the gamma chart looked freaky...the color...
Do Toshiba offer digital fax units rather than having to adjust a bunch of settings to try and get their analog units VoIP compatible or DSL filters? Or maybe fax to email enabled?
If a fax option is removed from the machine, do you need to disable it in settings so it stops displaying a message about line connection? Thx.
Almost forgot this post...never been back to machine since so guess it was wsd. Thank you all.
Different viscosity or temp rating?
Point well made Rusty...although 5560 fuser units are not without their issues!
It could be sitting idle for some time and just go into screen freeze. The customer has been advised about using correct drivers and not WSD, as discussed earlier in this thread. Their I.T. guys were...
Thanks for the info. Do you know or have you tried a firmware update to fix?
Literally first brother printer I have seen...no code on screen when frozen, have not printed codes..not sure how as no manual. Count is around 9.5k.
Power off/on will reboot and work for a while...tried unplugging for a couple of minutes. Is printer reset a good idea? Will it lose any settings?
Thanks in advance.
Did you ever resolve this?
Try changing bias blocks that charger contacts in EPU
Check paper in tray matches what the machine displays is in the tray
Thermopiles :)
check scanner carriage for distortion
Sensor actuators do get worn, guide and mylars that sensors are housed in get worn, guides on side door around bypass roller get worn, try extra wrap on actuator springs
08-2365 set to 0 disables the message :)
Fuser is biggest cause of noise on that series machine
If it prints without blue background I'd check scanner/optics alignment. Does it still have background on black only copy?
Check the drum drive, pin in drive shaft sheers creating drive issues & noise
Pixel count % gives you the print ratio % for standard size paper. 9 Start 104.
Problem was cartridge drive not releasing due to broken front door linkage. :D