Search:

Hi All I have a KM 364e device that the auto colour option is not available in copy mode but it is available in the scan mode.

The clear all data has been done ( factory settings ) and the...

Hi I will have to agree with the others retrace your steps as for the noise from your fuser it was probaly coming from fuser bearings but in that case oiling them will work for short time proper fix...

Hi if you say you done all the above then you are going to have change the main board but before you do that do trouble reset as well as a system error clear as well as a nic recovery and see if that...

Hi have you tried configuring the laptop directly to the MFP by changing your network settings on your PC to comm with the MFP and try printing via IP once you are able to ping the MFP and vice...

Hi please send pics of transfer belt itself would like to physically see the line on belt but I would have to agree with the other guys check for those staples. Good luck:confused:

Hi seeing as you pretty much changed all the boards on this MFP would suggest running this MFP with network cable unplugged for a day if you can otherwise change IP address you might have a corrupt...

Hi you have yourself one massive job there suggest you uplift this machine and take to your workshop becuase you going to have to strip the entire rear and front section out to get the toner...

Hi guys thanks for all your help you were spot on with that third roller easy to miss if do not know what you are looking for I have forwarded this info to SA support team and hope no one :)here...

We had a similar problem but our machine loosing developer and was not leaking developer was leaving the imaging unit K with the toner we did everything that you have done but ended up stripping the...

If you change the paper direction assuming this is an A4 sheet is there change cannot see this being a physical problem on the machine if you have a look at the logo it has no issues however the...

The firmware and solution rom should have 24702fixed this but you say when the machine recieves a print job it does this it could be that the machine is recieving a corupt data packet if you can...

Hi I have a C224 with about 80K prints on it Iam getting a repeated indentation on the paper after fusing has taken place cannot see any bulges or knicks on the pressure roller or fusing belt have...