Its in your manual, service mode Copier>Option>Acc>HCC-P set to 1 for letter, 0 for A4
Type: Posts; User: 20 year tech
Its in your manual, service mode Copier>Option>Acc>HCC-P set to 1 for letter, 0 for A4
Are you using OEM toner in the machine ? OEM fuser parts ? Also what paper type are you using ? Check or change the paper type settings, that would be the only thing I would adjust if using OEM...
Just because they may look the same does not make it so. You are trying to make a Frankenstein machine, as the others have said you are likely wasting your time and may brick both devices.
Check to see if restrict printer jobs is set to on, Settings and registration>Function settings>Printer>Restrict printer jobs. set it to off if it is on.
Dont remember the jam code on mine but I just saw something similar this week on a 45 series with a inner finisher. Turned out to be the inlet sensor arm on the finisher was dislodged. If yours has...
The lock symbol indicates an encryption kit installed I believe, as far as the admin password try using administrator and leave the password blank, have seen that work after a pw clear before, good...
If the cleaner keeps hanging up yes change the charge assembly. also check the connector for the cleaner motor.
e066 is a pre transfer wire cleaning error. the cleaner is probably hung up, remove the pre transfer charge assembly and make sure the cleaner moves freely.
Try installing a new toner bottle and let the machine cycle it should go away after that
Have a Brother PT-2430pc label printer that the cassette cover hinge has cracked because some one tried to close it incorrectly. I have spent way too much time looking online for this and am...
Just had a c5550 doing this yesterday, did an RCON clear and rentered door specs to no avail. checked the esupport site and they had a kbase article about reformatting the HDD. did that and it fixed...
Plus 1 on this reply, I normally replace the drums with the developers for this reason.
In your manual look in the troubleshooting section for startup system failure diagnosis. It will walk you thru the procedure to determine where the problem lies.
I cant find any reference to that code anywhere, start by checking thermistors, heaters etc as others have mentioned,does the code happen with the door open ? look at the frame connectors on the...
Happy New Year All !!
Merry Christmas to all.
Hope you all get to spend some time with loved ones and appreciate all that is good in life.
https://youtu.be/XMgxfkwZL4k
Thank you to all of those that have served our great nation.
Whats the serial number ? Canon esupport on the parts lookup page there is a serial lookup tool, just enter the first 3 letters and it tells you the model.
They should be on the communication report. I Dont have one of these around to look at but they are like an imageclass machine correct ?
Oh well so much for my fax board idea. If you haven't already done so first check the outlet, after that re-seat all the connectors on the main controller and DCON than reload system software, for...
Have not seen it with that model but have seen that issue caused by a bad fax board. if it has one disconnect it or swap it out and see if your problem goes away.
Should be the same as other canon's, in service mode>fax>sssw>sw01 set bit 0 to a 1 errors should than be on the reports
Its in version 3 of the part catalog FM1-U981-000 Cable,Thermoswitch picture says it goes to connector J3203.
Actually found this video in the industry news thread, if you have never seen Andy Slawetsky do industry interviews and the Industry Analysts site I recommend checking them out, great info from the...
Yup pretty impressive feat when you think about it. Been doin this stuff since 1991 and to this day I still tell folks from time to time that its a wonder these machines work at all.