Ok, today I mounted a new CPU board and the machine is working fine.
I also tried to install the old STRB but it doesn't work :(
Thanks for the reply :)
Type: Posts; User: uullxx
Ok, today I mounted a new CPU board and the machine is working fine.
I also tried to install the old STRB but it doesn't work :(
Thanks for the reply :)
Hi, I have the same problem ... :(
I replaced the STRB and now the machine loads the firmware successfully. But it still doesn't start. It stops at 25%
I cannot access the service mode. In a...
I double-checked everything from the beginning and realized that the hard drive was disabled.
I don't understand how this could have happened ... :(
I have enabled it again and now the machine is...
Thanks everyone for the answers.
I imported the backup of the settings and now the machine prints from the usb memory. :)
However, it does not print some PDFs from a PC: the blue LEDs flash while...
Hi everyone, I have a problem with a c284e.
After executing memory clear, the machine no longer prints from USB.
In the administrator settings I can only enable scan to USB, but there is no longer...