Search:

Type: Posts; User: poultryman17

Search: Search took 0.01 seconds.

  1. Replies
    6
    Views
    6,162

    Re: XN-5163 Maintenance counter reset

    There is also a MS810CRUM chip you can replace on the fuser itself (sits under black casing facing you when you remove from the machine) that will reset the maintenance count. Not sure where my...
  2. Replies
    8
    Views
    7,664

    [Misc] Re: XM3250 ADF multifeeding

    updated pn# is 41X1325
  3. [Misc] Re: Fax option disappears Model Lexmark MX3250

    Lexmark is aware of the problem. Our Lexmark rep sent my team updated firmware that will be coming out in May or June I believe for public release.
    Just hang in there.

    Doug
  4. Replies
    8
    Views
    865

    [Jamming] Re: 363 df jamming 2nd side

    In response to Sharp reimbursing for sensors replacement, please keep in mind that ALL the sensors in the unit need to be replaced for the $88 reimbursement. Not just the one that is bad. Page 7 of...
  5. [Jamming] Re: Sharp MX-5001n Jamming in registration area

    Just an added note, if you replace the door per the bulletin, you will need to transfer the "black reference" tape for lack of a better term attached to the old door (directly across from the...
  6. Re: Fax not showing up after main board replacement MX-2610

    Bet your "old school" coworker knows how to read a manual
  7. Re: Externam Memory: This function is currentyly not available.

    You keep saying "we" tried this, "we" did this in all your posts and then throw your coworker "under the bus" for being old school. Kind of disrespectful I would say..just my two cents
  8. Thread: MX-FN10

    by poultryman17
    Replies
    0
    Views
    504

    [Electrical] MX-FN10

    I am looking for a wiring harness part number on the Sharp MX-FN10 Finisher. This harness connects to CN-16 on the Finisher Control PWB and runs to five sensors in the finisher. These sensors are...
  9. Replies
    8
    Views
    13,479

    [Error Code] Re: F9-88 Error Code on Sharp AR-M257

    Would also suggest checking connections of NIC card to make surely firmly connected. Maybe remove DIMM's and clean with a pencil eraser.
  10. Replies
    8
    Views
    13,479

    [Error Code] Re: F9-88 Error Code on Sharp AR-M257

    Had an issue just the other day with this. Customer was trying to print a recipe from some website with a tremendous amount of graphics. Machine would code out. Deleted print job from que and word...
Results 1 to 10 of 10