There is also a MS810CRUM chip you can replace on the fuser itself (sits under black casing facing you when you remove from the machine) that will reset the maintenance count. Not sure where my...
Type: Posts; User: poultryman17
There is also a MS810CRUM chip you can replace on the fuser itself (sits under black casing facing you when you remove from the machine) that will reset the maintenance count. Not sure where my...
updated pn# is 41X1325
Lexmark is aware of the problem. Our Lexmark rep sent my team updated firmware that will be coming out in May or June I believe for public release.
Just hang in there.
Doug
In response to Sharp reimbursing for sensors replacement, please keep in mind that ALL the sensors in the unit need to be replaced for the $88 reimbursement. Not just the one that is bad. Page 7 of...
Just an added note, if you replace the door per the bulletin, you will need to transfer the "black reference" tape for lack of a better term attached to the old door (directly across from the...
Bet your "old school" coworker knows how to read a manual
You keep saying "we" tried this, "we" did this in all your posts and then throw your coworker "under the bus" for being old school. Kind of disrespectful I would say..just my two cents
I am looking for a wiring harness part number on the Sharp MX-FN10 Finisher. This harness connects to CN-16 on the Finisher Control PWB and runs to five sensors in the finisher. These sensors are...
Would also suggest checking connections of NIC card to make surely firmly connected. Maybe remove DIMM's and clean with a pencil eraser.
Had an issue just the other day with this. Customer was trying to print a recipe from some website with a tremendous amount of graphics. Machine would code out. Deleted print job from que and word...