Search:

send me your email address maybe I can help

I would start with the service manual and DRUnification tool. Acquire the registration and density sheets to perform automatic adjustments of scaling, registration and density. Also note the LED...

What error code are you getting? It may be just a firmware mismatch.

At what point did I mention anything but the engine of the machine? If you understand that the laser writes to the drum and between the laser and the drum is a slit glass, then it would make sense...

Canon - imageRUNNER ADVANCE C3530i / C3525i - User's Guide

This should pull up the operators manual, look under trouble shooting > problems with printing results > white streaks appear > Cleaning...

You can try swapping drums before replacing one. If the code follows the drum by subcode, then it is definitely a bad drum. If it goes away, then it means there was some poor contact when the drum...

The one in Bold red!

Also check Service Mode Login

COPIR>OPTION>FNC-SW>SVMD-ENT

0=Default 2 + 8

1= 4 + 9

Try performing the following steps. Settings/Registration > Management Settings > Device Management > Settings for Service Representative Access Restriction > set to off.

Good Luck!

E061-0007-05 Laser power (Bk) upper limit error
Detection Description Laser power (LPW) determined at the time of potential control for Bk patch was DB h or higher.
Remedy [Related parts]
-...

For imagePress C10000VP/C8000VP ?

K 8534B001AA
C 8535
M 8536
Y 8537

Did you check the values of the service label inside the front cover. Do a P Print and check the values against another machine to see if anything jumps out at you.

Good Luck!

Check you PM

Check your PM

Check drum driver pcb J208 is connected, and J210 is fully seated.

I would start with a firmware update.

I don't have one to look at but when it goes thru the fixing unit and gets to the next junction gate is it on the right side of the gate or did it take the wrong path?

Check your PM

P000 - "Document detected in feed path before scanning"
This is a "residual" jam at power on condition. If there's no paper present in the feed path, then you probably have a faulty paper sensor....

Select scan and Send and then on the right side bottom of screen select Options then select TX Report.

Funny thing, the tool works fine on my laptop but my coworker gets the same "missing DLL file" message. We fought this for a couple of hours last week and gave up. I just loaned him my laptop.

Check your PM

Check for Power Over Ethernet (POI). If present have IT turn it off at the switch.

Check your PM

263-1630-05 Power supply error
Detection Description The 6 V supply to the Fixing Feed Driver PCB was not detected.
Remedy [Related parts] R1.00
- Harnesses connecting the DC Controller PCB...