thanx alot, that doesn't look so very hard. I think I'll take a look and see what's making the black to not turn thanx again
Type: Posts; User: 1stcavvet
thanx alot, that doesn't look so very hard. I think I'll take a look and see what's making the black to not turn thanx again
Do you know what actually drives the black developer? When look at the motor section in the parts manual it shows one motor called CYM drive and the other is called K drive. but in the...
I have a problem with the black developer unit not turning. I see in the manual there is a seprate motor for black. I can't find any info on the disassembly and removal. is it part of the main...
Clean the little skinny glass along the left side of the big glass. alcohol on a rag would do GOOD LUCK
I would start with unplugging all the connections. Starting from the connector for the formatter and including all the smaller connectors on the main PCB. ( small board same side). Something is...
There are a couple metal flaps, you can see them when you take out the toner, they are right above where you were pushing that cardstock thru. smart move by the way. any way lift the flat closest...
THANX
I'm replacing 2 color drums in this machine Do they automatically reset or do I need to run a procedure after installed? thanks
looking for a D1550 or even a D1350 customer wants on like the one they have already THANX Courtney
I have a customer in need of a ADF for their kyocera 3035 copier SRDF2 --- it doesn't have to be pretty-- but it has to be in good shape if it need the feed roller kit replaced that's ok PLEASE...
What am I missing here I even looked in the manual---what resets the --Replace the mk message----- is the drum or the dv unit reset itself. Can't find any procedure in the manual. maybe it's...
If you did't find it yet look for something hanging down just under the slit between the slit glass and main glass
I'd say right off the bat you have solenoids , that are firing at the same time, I say they are probably stuck closed it's worth taking the right side off and see if the solenoids are stuck closed or...
So sorry it's a hp designjet T920 just has 1 printhead probably about a 2 1/2" X 3" block. when I got there it said reseat printhead like someone had removed it and put it back. I...
customer called and said they needed new printhead, went out and installed new printhead. said to reseat printhead installed old printhead said reseat printhead Is this a carrier failure...
Sorry this is actually a t1300 not a t920 I'm figuring is the same sort of issue their IT guy said he updated the firmware ---so he probably never got it pulled down he thinks he downloaded...
Customer called said they are getting a message on their printer "faulty communication with firmware server" they said they tried to install new firmware---not sure if it was the reason they tried...
Are you pulling a blank page out of the machine, when this happens??? Right off the bat I'd say the paper feed solenoid is sticking That would be my guess.
do all the lights go on when it stops printing??? this machine is known for having formatter problems---unplug from computer and print somethings from the menus, reports, configuration page, menu...
flip the glass over and clean the white mylar on the end there are some small white tapes on the ends of the adf glass--- that might just be on the older sharps
probably would't hurt to clean the...
what ever color comes out on the paper that does not belong there, that toner cartridge is failing change that toner
is the laser shutter opening when you insert toner??? just asking
Any one remember how to get into service mode on this machine? I remember something weird like they did with the 1810 copier. hold down start and some other keys--- I have one of these with a...
that's if it's on the prints if they mean on the display ----then they're stuck in the start-up. usually they turned it off and back on again(could have had a power outage) either way you have to...
tear in the fuser film GOOD LUCK