ADF is DP-7110
Thanks
Type: Posts; User: copyTcat
ADF is DP-7110
Thanks
I will check again the switch under the ADF, Just wonder what simulation code can check the switch functionality.
Thank you all.
Thanks, We checked the switch and switch is working fine but machine still has issue. Just to mention Copier has only 5500 copies on it.
Copier was hit on top ADF during move but since when making copy or scan the machine will detect letter size paper (A4) as ledger 11x17 (A3). Cleaned all sensors under the glass. Removed the document...
Unable to install, It is asking for password to open the install files
Thank you all. Reloaded software and replaced hard drive just in case(was old) now printer work.
hnami , to reload firmware again to the printer will help? but printer will not stay on ready to connect.:confused:
We got a Xerox Phaser color 7800GX at client location that has green screen with xerox logo attempting to finish boot process and than machine reboot again and again. (Boot Loop)
We suspect the SD...
Recently Royal Imaging in California was sold to ACM Technologies Inc. AKA acmtech.com.
Over the last 25 years we were very happy with Royal Imaging that was located in Chatsworth CA. Since it was...
Do you have the part number for the housing where that knob is broken?
copydocinc, I do agree that main board can go bad and i doesn't worth to try to upgrade due to the fact the copier is missing most upgrades.
Let me add that transfer roller was replaced when...
Thank You all.
Just to clear, There is developer, As I mentioned a new genuine developer unit was installed few months ago.
And yes, It is getting around 4K pages on genuine cartridge that should...
Got client with old Copystar CS3035. Copier using over 8 waste toner containers every toner cartridge. Developer was replaced 6 months ago and calibrated. Making sense to start with newest firmware...
It is amazing you found this bulletin.
I am on the Kyocera dealer site kdaconnect.com and can not find this bulletin.
Can you post a link?
Meanwhile I got the part from an old broken printer...
arrow show the broken shaft that is part of of the unit
31228
Thanks for the help. BUT....I think you are both wrong.
I am looking for the paper cassette lift unit. it is around 1 feet longhas only one motor andgot the connector for additional tray on the...
Got Kyocera M3550idn copier 3 months old that paper cassette lift motor keep clicking. quick check show that the paper lift assembly is broken causing the clicking problem. Unit located on the lower...
Got issue with the copier. Hard drive clicks and need to be replaced.
Is it just replacing the drive or the system need to be uploaded? any instruction will help.
Thank you all
Hi guys, thanks
It was transfer roller causing this issue
Client got Di5510. Hard drive is clicking. Just wonder if replacing the HDD, how to reload the system to the hard drive.
Checked the transfer roller and had to add the missing springs from KM5050 but still getting same issue. I also tried to install used KM5050 transfer roller but same issue. (I not sure if they...
Kyocera copier KM3035 was in client storage for 2 years.
Recently trying to use the copier but getting very light copies (also when printing internal reports)
Installed new developer unit and...
Thanks KJG, i think you are correct, I also suspect the middle unit, I found the clutch assembly P/N but can not find the one way roller.
By the way, Can I install dual one way roller instead of the...
Got KM5050 kyocera,
Using the feeder or glass.
Client complain of papers jam at the fuser like accordion and sometimes copies image shifting to the side up to the point of getting half page image...
I think your client is printing labels with this machine. The glue fumes killing the drum