Search:

Yes, needs an Enabler GM1030 for print only GM2030 for print/scan

How old is the fuser?
I know those registration units a notorious as well. Maybe check that.

Its the CF card, make sure and get the right one pre loaded with firmware. Again, make sure your getting/ordering the correct card.

log onto the EWS via ip address. under the settings tab all the way at the bottom ther should be a home screen set up where you can check/uncheck options that are on the Control panel, see whats...

log onto the machine EWS via I.P. address. under the settings tab there should be a home screen setup option where you can check/uncheck what shows on the display.

i agree, hopefully HPI will be running on diffrent platforms now.

hp inc /hp enterprise. the official separation was Nov 1 i believe.

its the split probably.

ugh, was it under warrenty?

Sorry man I had to send mine back for warrenty, all i have is the scanner control board.

yea, turned out i was being shipped the wrong cf firmware card. 4650 is NOT the same as i was told and suspected.

i know on the 575 series this was an issue but you could see it.
Cause:

Rough handling during shipping can cause the scan module to become dislodged from the scan carriage.

...

So jet direct card out and there is no HDD, went out with a new formatter and CF fw chip and memory. Still has the error.
boots up, comes to ready for a second then goes to calibrate and pops the...

10-4

ive done that and a disk clear as well, and reloaded FW. It boots normally, then calibrates the goes ready for about a second before it codes.

I mean, all S**t points to boards/dimm etc. but what are the odds that 2 fresh sets do the same thing? might just have to consult Johnny Walker..

Nothing connected and jet direct card removed, it prints and engine test just fine.

Yea, Ive tried 2 new Formatters and 2dimm and 2 CFM cards..

got me stumped.
new formatter, new fw chip, new dimm. I have two new sets of each and none of them work. boots up, calibrates then goes right into error.
any ideas?

definetly not a xerox guy, but got dumped on me and hoping someone can help.
prints one sided just fine but duplex second side is all over the place, any drawer, any size media.
any ideas? ive...

check that toner cartridge, sounds like the drum to me.

turned out to be a damaged ribbon cable from the scanner itself.

ive replaced the control panel, formatter and the damn touchscreen still doesnt work, any ideas?

pm your email and ill send the complete manual

firmware and fuser are the most common issue. dont forget to remove any options when upgrading F/W