Hi,
Just throwing my experience with this code, it was so random as it could work for a couple of weeks then just throw this code up 5/6 times a day.
It was on a C250i and I’d followed all KM...
Type: Posts; User: mattcoop11
Hi,
Just throwing my experience with this code, it was so random as it could work for a couple of weeks then just throw this code up 5/6 times a day.
It was on a C250i and I’d followed all KM...
Have you checked “New release mode” in service as this will cause issues when new toners are replaced.
It should be set on “New Release Mode”
Sent from my iPhone using Tapatalk
Ive had something similar on 4e series, and it was to do with the position of the CCD. (Accidentally unscrewed the red marked screws which align the height of the CCD)
You wouldn’t expect it on a...
Have you recently inserted any new toners?
Do you use genuine or compat toners, I’ve had it before with the chip on one of the compat toners was at fault, and it was causing the machine to ask for...
What model are you doing this on?
If switch 227 hex 80 reverts back to hex 00 once you have pressed fix then you may need to update FW to latest then try doing the switch again.
Sent from my...
Switch 227 hex 80
Sent from my iPhone using Tapatalk
https://uploads.tapatalk-cdn.com/20200207/dc4e21a518b7c907456cb9c14e63694a.jpg
Problem will more than likely be with the part highlighted, if you take it off, it will more than likely have a crack...
Has anyone of the IU’s been rechipped? Katun chips can have this issue where the machine calibrates all the time.
Sent from my iPhone using Tapatalk
https://uploads.tapatalk-cdn.com/20190610/5cfc990ab472f16dc0106b950c81ee83.jpg
I haven’t checked the part no you’ve listed, but do you mean this part?
Sent from my iPhone using Tapatalk
Sounds more than likely the SSD Board, last one I did gave mfp controller N.G and that was a faulty SSD. Easy to do as long as you get the machine type write when reloading FW after replacing with...
Make sure that the from address which is in the communication settings when your about to scan is set to the admin email address.
Sent from my iPhone using Tapatalk
mcooper94@outlook.com
Thanks in Advance